In photography, an orb is a typically circular artifact on an image, created as a result of "flash photography illuminating a mote of dust or other particle. Orbs are especially common with modern "compact and ultra-compact digital cameras.
Orbs are captured during low-light instances where the camera's flash is used. Cases include night or underwater photography, or where a bright light source is near the camera. Light appears much brighter very near the source due to the "inverse-square law, which says light intensity is inversely proportional to the square of the distance from the source. The orb artifact can result from "retroreflection of light off solid particles, such as dust or pollen, or liquid particles, especially rain. They can also be caused by foreign material within the camera lens. The image artifacts usually appear as either white or semi-transparent circles, though may also occur with whole or partial color spectra, "purple fringing or other "chromatic aberration. With rain droplets, an image may capture light passing through the droplet creating a small rainbow effect.
"Fujifilm describes the artifacts as a common photographic problem:
There is always a certain amount of dust floating around in the air. You may have noticed this at the movies when you look up at the light coming from the movie projector and notice the bright sparks floating around in the beam. In the same way, there are always dust particles floating around nearby when you take pictures with your camera. When you use the flash, the light from the flash reflects off the dust particles and is sometimes captured in your shot. Of course, dust particles very close to the camera are blurred since they are not in focus, but because they reflect the light more strongly than the more distant main subject of the shot, that reflected light can sometimes be captured by the camera and recorded on the resulting image as round white spots. So these dots are the blurred images of dust particles.
In underwater conditions, particles such as sand or small sea life close to the lens, invisible to the diver, reflect light from the flash causing the orb artifact in the image. A strobe flash, which distances the flash from the lens, eliminates the artifacts. The effect is also seen on infrared video cameras, where superbright infrared LEDs illuminate microscopic particles very close to the lens. The artifacts are especially common with compact or ultra-compact cameras, where the short distance between the lens and the built-in flash decreases the angle of light "reflection to the lens, directly illuminating the aspect of the particles facing the lens and increasing the camera's ability to capture the light reflected off normally sub-visible particles.
Some "paranormal investigators have referred to orbs appearing in photographs from allegedly haunted locations as 'ghost orbs', 'spirit orbs' or 'angel orbs', and claim them as evidence of spirit presences representing the essence or soul of a departed person, in some cases claiming that orbs have appeared on command and may have images and faces visible within them when zoomed in.
An additional problem called backscatter occurs when flash light striking these suspended particles reflects back to the camera lens and records on the film as fuzzy white spots. Of course, backscatter can also be reduced by getting the camera as close to your subjects as possible, because the shorter that distance, the fewer the number of floating particles in front of the lens
|Wikimedia Commons has media related to Photographical orbs.|